Cars Running On Hydrogen

AUTHENTIC Magnum Digital Map Sensor Enhancer has been developed to engines installed with water4gas generators. Modifies MAP (Manifold Absolute Pressure) or MAF (Mass Air Flow) signal in fuel injected gas or diesel vehicles controlled by ECU. When installing an HHO electrolyzer more should be processed to achieve extreme MPG increases. After we inject hydrogen gas into the engine we need to reduce the fuel injection in the reason of economy enhancement. It will allow you to fine tune the fuel intake when applying HHO generator resulting perfect fuel savings, besides its ‘in dash’ design makes possible the adjustment while driving, testing. MAP sensor enhancer is not intended to be a fuel saver by itself but can warrant improvement of MPG if you use HHO electrolyzer. MAP is one of the sensors applied in an internal combustion engine’s electronic control system. It provides instantaneous manifold pressure information to the ECU. This is necessary to calculate air density & determine the engine’s air mass flow rate, which in turn is used to calculate the appropriate fuel flow. If you add hydrogen to the mix & really want to save fuel, you need to reduce the volume of original fuel. When you trick MAP sensor, the new fooled signal will tell the ECU not to deliver much fuel. Since the air/fuel ratio in injected up-to-date vehicles is regulated by the Electronic Control Unit (ECU) & most factory ECUs are set to maintain a 14.7:1 air/fuel ratio; this is known as a stoichiometric fuel mix, user is unable to trim manually or mechanically this ratio as by early models accordingly if you do not use MAP sensor enhancer you will not save much fuel despite this was the main reason you installed the H2O system for. * * 10-YEAR MAGNUM FACTORY WARRANTY * * Magnum Tuning has been dealing with manufacture of upgrades and fuel saver parts since 1994. Magnum’s experience warrants peak performance, reliability & perfect style. Magnum Parts are made in EUROPE.

MAGNUM DIGITAL MAP MAF ENHANCER Lincoln Town Car 4.6L EFIE HHO Chip

The FS2
The FS2 has been specifically tuned for the needs of HHO generator equipped vehicles. A dynamic 20MHz microprocessor, the FS2 will consider O2 levels, engine speed and load, intake air temp. and volume, along with many other variable to calculate HHO output and automatically adjust fuel delivery and timing for maximum gains.

Gains
The FS2 was designed to help your ECU accept HHO as a fuel supplement. Its output is dependent on the efficiency of your HHO system. When HHO is disabled the FS2 will automatically switch to its high efficiency, non-HHO maps and continue to produce gains of 15-18% over stock.

Installation/Use
Installation takes about 15 minutes and requires no special skills. Once installed, press the RESET button to calibrate and you’re done!
The FS2 does NOT include an OBD-II connector. It connects directly to the OBD-II port’s data lines. OBD-II scantools will not interfere with operation.

Fits
Base Limousine 4-Door
      4.6L 281ci V8 SOHC

Cartier Sedan 4-Door
      4.6L 281ci V8 SOHC

Executive Limousine 4-Door
      4.6L 281ci V8 SOHC

Executive Sedan 4-Door
      4.6L 281ci V8 SOHC

Signature Sedan 4-Door
      4.6L 281ci V8 SOHC

Lifetime Warranty

Satisfaction Guaranteed or Your Money Back

Volo FS2-HHO edition Fuel Chip for 1998 Lincoln Town Car 4.6L

Installing HHO PLUS Kit will increase your engines performance, increase MPG 30% minimum, eliminate harmful unsed fuel, clean engine of unused fuel deposits, increase your engines life expectancy . Our products are designed and manufactured in the European Union in our Company HHO Plus, in compliance with technical standards and industrial manufacturing of such products.

Technical Data and Additional Information:

- Generator Type: Dry Cell;

- Standard dimensions: 110×110x150 mm;

- Plates: 17;

- Voltage: 12/24V

- Standard electrical connections of the cell:

+ NNN – NNN + NNN – NNN + (N – neutral plate)

- Total area for gas production: 1050 cm2;

- Production of Hydrogen: 2.0 liters per minute (25A)

Parts List of the Kit:

This kit comes complete with all accessories required for the installation:

- Generator HHO Gas – Dry Cell with 17 plates in 316L stainless steel;

- Watertank in nylon (volume of 1 liter) with easy level check and opening for refilling;

- Control Relay 30A-12V DC
- Electrical cable HO7V K, 6 mm section, in red and black, suitable for all electrical connections;

- Fuse holder and fuse 30A;

- Safety nylon check-valve;

- Insulated Terminals and acessories for all electrical connections;

- High Pressure Hose for the HHO gas;

- Cristal PVC Hose for the electrolyte;

- Includes all the necessary connectors and sockets for the connections ;

- Electrolyte – Potassium hydroxide (KOH)

- Extender for the lambda sensor – electronic fuel injection;

- Installation Manual

Kit HHO DC2000 Automobile Fuel Saving